Quality reproduction of the original for various models. This Pitman Arm is made to precise factory specifications, heat treated, and precision-machined to a fine tolerance. Installation of a new Pitman Arm will improve steering response and reduce wander & vibration. Included in this kit: Pitman Arm, dust seal, castle nut, cotter pin, & grease fitting.
Specifications are listed below:
- Stud Diameter (small end of taper) = 0.585
- Sector Shaft Diameter = 1.155
- Sector Shaft Spline Large Inner Diameter = 1.155
- Length center to center = 5.78
- Male key-way
- Offset = Down
- Number of splines = 32
- Hardware Included
- Bent-Arm type
- Arm Fixture = Stud
- Arm fixture stud thread-hole inside diameter = 1/2 - 20
Fits:
- 1967-69 Camaro Z-28
- 1968-74 Nova w/pwr str, fast ratio, & 5.75" center to center
- 1967-68 Firebird
- 1971-72 Ventura w/fast ratio steering
